Sherwin-Williams Floorcoating Resudeck ST

Sherwin-Williams Floorcoating Resudeck ST

Flexible, resilient floor coating

Resudeck ST is a two-pack, high build, hard wearing polyurethane floor coating providing a tough flexible finish with resistance to chemical attack.

Resudeck ST is suitable for wet environments and is resistant to hot water. By incorporating suitable aggregates, anti-slip finishes can be created with a range of thicknesses and textures.

Advantages

• High-build finish
• Flexible
• Hygienic and easily cleaned
• Excellent slip resistance with the addition of aggregates
• Ease of application
• Excellent high gloss finish
• Low odour
• Very low VOC content
• Solvent-free

Recommended Use

• Mezzanine areas
• Food processing and beverage areas
• Plant rooms
• Aviation and automotive areas
• Internal car park decks
• Factory units
• Asphalt areas
• Excellent for all demarcation and walkways

Surface Preparation

New Concrete Floors: New concrete must be clean, sound, dry, fully cured and surface laitance removed by vacuum enclosed shot blasting or mechanical grinding, a minimum strength of 25N/mm² is required. Existing Concrete Floors: Remove all dirt, oil, grease, old paint or any other surface contaminants by vacuum enclosed shot blasting, scarifying or mechanical grinding.

Fats, oils or greases must be removed by mechanical means and detergent washing and making sure all residue of detergent is washed and removed by rinsing with clean water. Local repairs should be carried out using Resuscreed PA. Existing Floors (previously coated): All previous coatings and loose floor paints must be removed by mechanical preparation as described in the above section and primed as specified.

If the old resin flooring cannot be removed then please consult with our technical team for advice on inter-coat adhesion and suitability, as it may not be compatible with the existing floor coating. Where Resudeck ST is applied to masonry/concrete surfaces, care must be taken to ensure that surface preparation is thorough but does not disfigure the surface.

Application

Mixing: Mix the entire contents of the base with the hardener. If a separate mixing bucket is being used mix thoroughly ensuring all contents of both components are removed from the buckets supplied. Mix using a slow speed electric mixer for approximately two to three minutes until the two components are fully combined. The mixed unit should be applied immediately by roller, brush or squeegee with a consistent procedure. Floor areas should be cross-rolled to ensure even application and to minimise roller marks.

Full product data sheets and safety data sheets are available on request.